RaptorSource.com
Raptor 350 => 350 Maintenance => Topic started by: JoeSchmoe on July 27, 2011, 07:15:00 AM
-
Hello folks! My neighbor stripped out the chain/sprockets on his 350 Raptor.
He's having trouble with the nut holding the front (little) sprocket. Not coming off.
Before he REALLY whales on it he'd like to know if it is regular thread or reverse thread?
Joe
-
I haven't worked on a 350 before but I imagine it should be the same principle as a 700s...make sure the locktab is bent off and use an air impact or breaker bar on it (best to do it with the trans in neutral) and put the parking brake on, wedge the rear sprocket and/or rotor and use a breaker bar.
-
Wow, thanks for the quick response!
Do you remember if it was reverse threaded?
Joe
-
Nope mine wasn't...righty tighty, lefty loosey.
-
Thank you!! Or perhaps, thank you from my neighbor! He wants to go out this weekend :)
Joe
-
Nope mine wasn't...righty tighty, lefty loosey.
<resists urge for off-topic harassment>
:rofl:
hope he gets it off. TOok me a bit on my 660. It was on there pretty good.
-
It's done! He ended up wrapping the back of the sprocket with a wet rag, heating it with his torch, loosening the nut, and pouring water on it to cool it down.
He's one happy camper. Maybe one day he'll join the 90s and get a computer :rolleyes:
Joe
-
It's done! He ended up wrapping the back of the sprocket with a wet rag, heating it with his torch, loosening the nut, and pouring water on it to cool it down.
He's one happy camper. Maybe one day he'll join the 90s and get a computer :rolleyes:
Joe
:rofl:
-
Heat's not good for any seals that might be behind it, but glad to know he got it fixed...